Basic Looping - Lexicon JAMMAN Mode D'emploi

Basic Looping

DISPLAY
+ = Loop displayed is cued to begin at
start of next phrase
- = When recording first loop,
indicates less than 1 second of
memory remains
1-8 = ID number of current, or cued loop
• = Indicates displayed loop is the
final loop of the current sequence
0 = ready to define the first loop of a
new sequence
Chase pattern indicates loop recording.
RESET/BYPASS
In Punch-In Loop mode, immediately
resets the unit to begin a completely
new sequence of loop recording. In
Phrased Loop mode, reset will occur at
the end of the current loop.
English
FUNCTION
Selects MUTE, LAYER, or
REPLACE as the dub function
assigned to TAP.
RESET/BYPASS FUNCTION
MUTE/
LAYER/
REPLACE/
LEDs (activated via FUNCTION) show
selected and cued dub functions.
16
SELECT
Selects among a maximum of 8 loops. (Loop ID
number is displayed.) The actual number of
loops which can be made is determined by the
length of your first loop.
LED lights while first loop is being
recorded, then blinks at the tempo
set by that loop.
TAP
TEMPO
SELECT
TAP
First push starts recording. Second
push stops recording and immediately
plays the loop. Subsequent pushes turn
on and off the selected dub function.
Off: Function not selected
Blinking: Function cued
On: Function active