Télécharger Imprimer la page

Ryobi RBV26 Manuel D'utilisation page 20

Masquer les pouces Voir aussi pour RBV26:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 3
EN
FR
DE
ES
Clean the surface around the fuel cap to prevent
Q
con tamination.
Loosen the fuel cap slowly by turning counterclock-
Q
wise.
Pour the fuel mixture carefully into the tank.
Q
Clean and inspect the fuel cap gasket before
Q
replacing the fuel cap.
Replace the fuel cap and tighten it by turning it clock-
Q
wise.
Wipe spilled fuel from the product.
Q
Move at least 9m. away from refueling area before
Q
start ing the product.
NOTE: It is normal for smoke to be emitted from a new
engine during first use.
WARNING:
Check for fuel leaks. A leaking fuel cap is a fire
hazard and must be replaced immediately. If
you find any leaks, correct the problem before
using the product. Failure to do so could result
in a fire that could cause serious personal
injury.
OXYGENATED FUELS
DO NOT USE E85 FUEL. IT WILL VOID YOUR
WARRANTY.
NOTE: Fuel system damage or performance problems
resulting from the use of an oxygenated fuel containing
more than the percentages of oxygenates stated previ-
ously are not covered under warranty.
Ethanol. Petrol containing up to 10% ethanol by volume
(commonly referred to as E10) or 15% ethanol by volume
(commonly referred to as E15) are acceptable. Do not
use E85 fuel.
STARTING AND STOPPING
See Figure 7.
To start a cold engine:
DO NOT squeeze the throttle trigger until the engine
starts and runs.
Lay the blower/vacuum on a flat, bare surface.
Q
PRIME - Press the primer bulb 7 times.
Q
SET the start lever to the START position.
Q
PULL the starter grip until the engine starts.
Q
NOTE: Squeezing and releasing the throttle trigger
releases the start lever to the RUN position.
To start a warm engine:
PULL the starter grip until the engine starts.
To stop the engine:
Press and hold the switch in the stop "o" position until the
engine stops.
See Figures 8 - 9.
WARNING:
Do not place blower on top of or near loose
debris or gravel. Debris may be sucked into
blower intake vent resulting in possible damage
IT
PT
NL
SV
DA
English(Original instructions)
NO
FI
HU CS RU
to the unit and could result in serious personal
injury.
To keep from scattering debris, blow around the
Q
outer edges of a debris pile. Never blow directly into
the center of a pile.
Operate power equipment at reasonable hours only -
Q
not early in the morning or late at night when people
might be disturbed. Comply with the times listed in
local ordi nances.
To reduce sound levels, limit the number of pieces of
Q
equipment used at any one time and operate blower
at the lowest possible throttle speed to do the job.
This may also reduce vibration levels.
Conserve water by using power blowers instead
Q
of hoses for many lawn and garden applications,
including areas such as gutters, screens, patios,
grills, porches, and gardens.
Check your equipment before operation, especially
Q
the silencer, air intakes, and air filters.
Use rakes and brooms to loosen debris before
Q
blowing.
In dusty conditions, slightly dampen surfaces when
Q
water is available.
Watch out for children, pets, open windows, or
Q
freshly washed cars, and blow debris safely away.
Hold blower, as shown in Figure 9, so the air stream
Q
can work close to the ground.
After using blowers or other equipment, CLEAN UP!
Q
Dispose of debris properly.
The high velocity nozzle is specifically designed for
Q
wet sticky leaves. It allows you to scrape wet leaves
or debris while operating the blower.
CRUISE CONTROL
See Figure 10.
The cruise control can be used to operate the blower
without holding the throttle trigger.
To engage the cruise control:
Pull cruise control lever back towards user, and stop
Q
at the desired throttle setting.
To release the cruise control, push cruise control
Q
lever all the way towards the front of unit.
VACUUM OPERATION
See Figure 11.
WARNING:
Keep the silencer and all hot surfaces of the
blower/vacuum away from your body. Failure to
do so could result in possible serious personal
injury.
Install the vacuum tubes and the bag. Refer to the
Q
As sembly section earlier in this manual.
Start the blower. Refer to Starting and Stopping
Q
earlier in this manual.
Place the vacuum bag strap over your right shoulder.
Q
Hold the upper handle in your left hand and the
vacuum handle in your right hand.
18
RO PL
SL
HR ET
LT
LV
SK BG

Publicité

loading