Unold 68860 Mode D'emploi page 40

9. Plug the mains plug into an electrical outlet. The display lights up.
10. Press the "Mix" button.
11. The preset time of 4 minutes will be shown in the display. Press the "+" or
"-" buttons, to adjust this time according to your desires. The time adjust-
ment is possible as long as the numbers in the display are flashing.
12. Wait several seconds. The flashing stops and the kneader starts to turn.
The kneader starts to turn. This program runs for the factory-set time of 4
minutes or for the duration of the time specified by the user. The time is
appropriately shown in the display. The subsequent procedure is described
starting from point 20.
Making noodles without egg
13. Close the lid of the appliance.
14. Plug the mains plug into an electrical outlet. The display lights up.
15. Press the "Mix" button.
16. The preset time of 4 minutes will be shown in the display. Press the "+" or
"-" buttons, to adjust this time according to your desires. The time adjust-
ment is possible as long as the numbers in the display are flashing.
17. Wait several seconds. The flashing stops and the kneader starts to turn. This
program runs for the factory-set time of 4 minutes or for the duration of the
time specified by the user. The time is appropriately shown in the display.
18. Immediately pour the weighed water slowly into the kneading container
through the opening in the lid.
19. The subsequent procedure is described starting from point 20.
Extruding pasta
20. When the set time has elapsed, the kneader stops and a signal tone sounds
three times.
21. Now press the "Extrude" button. The appliance starts to extrude pasta.
You can cut off the noodles at the desired length with the provided dough
scraper or with a small, sharp knife
22. When pasta extrusion is concluded the signal tone sounds four times and
the appliance stops extruding pasta.
23. When you stop making pasta, unplug the plug from the electrical outlet. The
device is not safely switched off until after it has been unplugged from the
electrical outlet.
Always unplug the appliance from the electrical outlet before disassembly
and cleaning.
After you have finished making pasta, disassemble the pasta machine
immediately and clean all the component parts. Dried dough can make it
difficult or impossible to disassemble the machine.
40
Copyright UNOLD AG | www.unold.de