The Instrument Mode Of Working; Configuration - ero electronic FKS-MK1 Manuel De Service

Sh2
Fig.9
5) Solder the Sh2 pads (See Fig. 9).
6) Re-insert until the first stop the instrument into the case.
7) Plug-in the terminal block cover.
8) Push the instrument completely into the case.
9) Switch on the instrument.
fks-MK1-1-A0.pmd 5

4 . 4 . 4 . 4 . 4 . THE INSTRUMENT MODE OF WORKING

THE INSTRUMENT MODE OF WORKING THE INSTRUMENT MODE OF WORKING THE INSTRUMENT MODE OF WORKING THE INSTRUMENT MODE OF WORKING
The instrument can be operative in two different modes:
configuration mode and operating mode. They can be
selected from the keyboard, as described in the
corresponding sections.
On switching on, the instrument starts in the "mode" it was in
before switching off (configuration mode or operating mode).
5 . 5 . 5 . 5 . 5 . C O N F I G U R A T I O N C O N F I G U R A T I O N C O N F I G U R A T I O N C O N F I G U R A T I O N C O N F I G U R A T I O N
5 . 1 Keyboard functions during configuration 5 . 1 5 . 1 Keyboard functions during configuration Keyboard functions during configuration Keyboard functions during configuration
5 . 1 5 . 1 Keyboard functions during configuration
m o d e m o d e m o d e m o d e m o d e
F U N C F U N C
F U N C F U N C F U N C it saves the new value of the parameter selected
and goes to the next parameter (increasing
order).
R E V R E V R E V R E V R E V it allows to scroll back the parameters without
memorizing the new setting.
Increases the value of the selected parameter.
Keeping the pushbutton pressed, the variation
speed is increased.
Decreases the value of the selected parameter.
Keeping the pushbutton pressed, the variation
speed is increased.
5 . 2 5 . 2 5 . 2 5 . 2 5 . 2 How to start the configuration mode How to start the configuration mode How to start the configuration mode How to start the configuration mode How to start the configuration mode
On switching on, fore conditions can be shown:
A) the display shows a number: the instrument is in
operative mode and in "normal display mode".
B) the display shows "E E E E E ." and a number: the instrument
have detected an error (see chapter "error messages"
in this manual).
C) the display shows "_ _ _ _ _ ooo ooo" or "- - - - - ooo ooo ooo
ooo
instrument is in operative mode and in "normal display
mode" but an out of range condition is detected.
D) the display shows "COnF COnF" : the instrument is in COnF COnF COnF
configuration mode.
GB
5
09/05/2006, 15.06
ooo ooo": the ooo
ooo