ero electronic FKS-MK1 Manuel De Service page 16

P 1 2 P 1 2 P 1 2 P 1 2 P 1 2
Alarm 2: action Alarm 2: action Alarm 2: action Alarm 2: action Alarm 2: action
This parameter is only available if the function of output 2 is
configured as alarm 2 ("P10" different from "nonE" or "CooL").
Range: dir = direct action (the relay is energized or SSr=1
in alarm condition)
rEV = reverse action (the relay is de-energixed or
SSr=0 in alarm condition)
N O T E N O T E
N O T E N O T E N O T E :
- If LBA is enabled on output 2 ("P56" = "Out2", see "Advanced
configuration parameters"), the same selection is set on "P61".
P 1 3 P 1 3 P 1 3
P 1 3 P 1 3
Alarm 2: standby function Alarm 2: standby function Alarm 2: standby function
Alarm 2: standby function Alarm 2: standby function
This parameter is only available if the function of output 2 is
configured as alarm 2 ("P10" different from "nonE", "nALF",
"CooL").
Range: OFF = standby function disabled
ON = standby function enabled
N O T E : N O T E : N O T E : N O T E : N O T E :
- The standby function can "mask" an alarm condition at the
start up (if the alarm is programmed as process alarm), or
at the start up and after a set point change (if the alarm is
programmed as band or deviation), until the process
variable reaches the alarm threshold plus or minus the
hysteresis.
fks-MK1-1-A0.pmd 10
P 1 4 P 1 4 P 1 4 P 1 4 P 1 4
SMART function SMART function SMART function SMART function SMART function
This parameter is available only when at least one control output
is configured.
Range: dIS = Smart function disabled.
Enb = Smart function enabled (activating/
deactivating the function is not
parameter protection rule).
Enb.P = Smart function enabled (activating/
deactivating the function is is is is is subject to the
parameter protection rule).
P 1 5 P 1 5 P 1 5
P 1 5 P 1 5
T T T T T ype of control action ype of control action ype of control action ype of control action ype of control action
This parameter is available only when at least one control output
is configured.
Range: Pid = The process is controlled by PIDaction.
Pi = The process is controlled by PI action.
N O T E : N O T E : N O T E : N O T E : N O T E :
- if the control action type was changed (parameter "P15") and
the configuration procedure has been enabled while the
second part of the SMARTalgorithm (ADAPTIVE) was in
progress, the "Pb" and "ti" parameters will be updated with
the values calculated by the first part (TUNE) of the SMART for
the new type of control action.
If these values are incorrect:
- The "E.120" error message will be displayed for
2 seconds;
- parameters "Pb" and "ti" will not be updated;
- the instrument will work with a PI control action
(parameter "td" will be forced to 0).
In this situation the SMART function should be In this situation the SMART function should be
In this situation the SMART function should be In this situation the SMART function should be In this situation the SMART function should be
started again started again started again started again started again. . . . .
GB
10
09/05/2006, 15.06
not not
not subject to the not