Operating Mode - ero electronic FKS-MK1 Manuel De Service

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

P 1 6
P 1 6
P 1 6
P 1 6
P 1 6
Input threshold to enable Soft Start t t t t
Input threshold to enable Soft Star
Input threshold to enable Soft Star
Input threshold to enable Soft Star
Input threshold to enable Soft Star
This parameter is available if at least one control output has been
configured.
Range:
- between the range limits of TC/RTD (see "P1")
- between the limits of "P3" and "P4" for linear inputs
P 1 7
P 1 7
P 1 7
P 1 7
P 1 7
Timeout selection
Timeout selection
Timeout selection
Timeout selection
Timeout selection
This parameter allows to set the time duration of the timeout
used by the instrument during the parameter modification in

operating mode.

Range:
tn.10 = timeout 10 sec
tn.30 = timeout 30 sec
P 1 8
P 1 8
P 1 8
P 1 8
P 1 8
Safety code
Safety code
Safety code
Safety code
Safety code
Range: 0 =
No protection. The device is always in UNLOCK
condition and all the operating parameters can
always be modified
1 =
Total protection. The device is always in LOCK
condition and no operating parameter (with the
exception of parameters "SP" and "n.rST") can
be modified
2/4999 =
Code to enable/disable the protection of the
operating parameters (See "nnn")
(Parameters "SP" and "n.rST" are NOT subject
to protection).
5000/9999 =
Code to enable/disable the protection of the
operating parameters (See "nnn"). Parameters
"SP","n.rST", "AL.1" and "AL.2", are NOT subject
to protection.
THE LOCKED PARAMETERS WILL NOT BE DISPLAYED
fks-MK1-1-A0.pmd
11
N O T E S
N O T E S :
N O T E S
N O T E S
N O T E S
a) To enable/disable the SMART algorithm see also "P14"
b) When a numerical code is selected, it will no longer be displayed
(the display will show "2"). If the code is forgotten a new one
must be set.
The basic configuration of the instrument is ended, and the
display shows:
C.End
Press FUNC
FUNC
FUNC
FUNC
FUNC to return to the start of the configuration.
COnF
To go to operating mode press REV + FUNC
REV + FUNC
REV + FUNC
REV + FUNC
REV + FUNC for 3 seconds.
N O T E :
N O T E :
N O T E :
N O T E :
N O T E :
The "Advanced configuration parameters" gives the programming
of the parameters from "P51" to "P66".
GB
11
09/05/2006, 15.06

Publicité

Table des Matières
loading

Table des Matières