Siemens SINUMERIK 840D sl Manuel De Mise En Service page 507

08/2005
SubBlock
Pictogramme pour pas de programme secondaire – SEFORM(..., 1, ...)
Sync
Pictogramme pour marques de synchronisation – par ex. WAITM(...)
Cycle
Pictogramme pour cycle
GeoProz
Pictogramme pour élément de contour
[SyncMarks_User]
Les constructeurs peuvent saisir ici leurs extensions pour les marques de
synchronisation.
;Definition of synchronization marks (search texts)
;sync1 = WAITM*(*n,*c,*c,*c,*c,*c,*c,*c,*c,*c,*c)
;
;
;
;
;
;
;
;
;
; Add additional / language dependent Text:
; WAITM*(*n,*c,*c,*c,*c,*c,*c,*c,*c,*c,*c) "$85000 The Text"
;
;sync1_Ico = clock.bmp
;
;sync1_Chans = 1,2,4
;
;
;
;
;
;
;
;
;
;
;SIEMENS
[SyncMarks_Siemens]
sync1 = WAITM*(*n,*c,*c,*c,*c,*c,*c,*c,*c,*c,*c)
sync1_Ico = clock.bmp
sync1_Chans =
;USER
[SyncMarks_User]
© Siemens AG 2005 All Rights Reserved
SINUMERIK 840D sl/840D/840Di/810D MES HMI (IAM) - Edition 08/2005
'#' : seperator: text before is searched in one
channel, text behind in all others.
It isn't possible to synchronize this kind of
synchronization marks !!!
'*n': identifier for synchronization numbers
WAITM(*n,1,2,3)
'*c': channel WAITM(1,*c,*c,*c), if own channel
is missing, it will be added like WAITM-strategy
belonging icon for defined sync mark
Project the channels to synchronize here
e.g.: you have a M-function (M4711)
to synchronize the channels 1, 2 and 4
Then you can write here: syncX=1,2,4
If you synchronize the part programs the
channel 3 will not be considered.
If you don't project anything here, in all
channels must stand the M4711 call
respective if there are *C in [SyncMarks]
only these channels will be synchronized.
Mise en service HMI Advanced (IM4)
2 Fonctions / paramétrage
IM4/2-111