Siemens SINUMERIK 840D sl Manuel De Mise En Service page 490

Mise en service HMI Advanced (IM4)
2 Fonctions / paramétrage
AUTO_V_ISTW=7
AUTO_V_ZOOM=7
AUTO_V_NCPR=7
AUTO_OP_NCPR=7
AUTO_ED_NCPR=7
AUTO_SYNAKT=7
AUTO_INCHMET=7
[Customer]
MDASingleSTEP=yes
ONLY_MKS_ToolBaseDistToGo=no
NcVersionCheck=true
[BlockSearch]
; Shows (SeruproEnabled=1) or
; hides (SeruproEnabled=0)
; the softkey used to do a block search in mode "programtest".
; The softkey appears in both dialogs
; "Blocksearch Searchposition" and "Blocksearch Searchpointer"
SeruproEnabled=1
; When doing a block search in mode "programtest" you can do
; a multi-channel block search. There are 4 channel-configurations which
; define the NC-channels being affected by the block search:
; SeruproConfig =
; 1:
; 2:
;
; 3:
;
; 4:
SeruproConfig=1
IM4/2-94
; watch windows of Actual-values,
==>7 Suggestion everyone
; Spindels, G-Functions, Aux.-Functions,
; Feedrate, Tools or Axis-feedrate at AUTO mode
; Zoom actual values at AUTO mode
==>7 Suggestion everyone
; Programm-overview at AUTO mode
==>6 Suggestion operator
; load + select Progam at AUTO mode
==>6 Suggestion operator
; Alter enable status of Prog at AUTO mode
==>5 Suggestion machine setter
; synchron actions at AUTO mode
==>5 Suggestion machine setter
; Switch inch/Metric at AUTO mode
==>6 Suggestion operator
; Due to performance issues the functionality offered with respect to
; block correction, block view and block search depends on the
; Nc-version currently used.
; However, to get access to the whole functionality, regardless of the
; Nc-Version in use,
; set the flag NcVersionCheck to False.
selected/active channel
selected/active channel and all channels having selected the same
workpiece as the active channel
selected/active channel and all channels having selected the same
chanels's mode group
all NC-channels
SINUMERIK 840D sl/840D/840Di/810D MES HMI (IAM) - Edition 08/2005
© Siemens AG 2005 All Rights Reserved
08/2005