Siemens SINUMERIK 840D sl Manuel De Mise En Service page 493

08/2005
[DriveTextFiles]
ALDEV_80E5=f:\dh\mb.dir\aldvs_
ALDRV_80E5=f:\dh\mb.dir\aldrs_
;ALDEV_808F=f:\dh\mb.dir\aldvu_
;ALDRV_808F=f:\dh\mb.dir\aldru_
ALDEV_x=f:\dh\mb.dir\aldvp_
ALDRV_x=f:\dh\mb.dir\aldrp_
[IndexTextFiles]
ALNX=f:\dh\mb.dir\alnx_
ALSI=f:\dh\mb.dir\alsi_
[DEFAULTPRIO]
CANCEL=100
RESET=100
POWERON=100
NCSTART=100
PLC=100
PLCMSG=100
MMC=100
[PROTOCOL]
Filter=Expression
Records=150
DiskCare=1
La stratégie multi-fichiers peut également être sélectionnée par l'entrée DiskCare
dans le fichier INI.
© Siemens AG 2005 All Rights Reserved
SINUMERIK 840D sl/840D/840Di/810D MES HMI (IAM) - Edition 08/2005
; default definition of the priorities of the different alarm types
; This section defines different characteristics of the protocol that
; specifies how particular error messages are to be registered.
Vous trouverez des informations détaillées sur l'écriture d'expressions
de filtre permettant de commander l'affichage des messages au
chapitre "Affichage du journal des alarmes".
; Criteria for selecting the alarm messages to be recorded. The notation
; is described in SINUMERIK 840D OEM package HMI User's Manual.
; Characterizes the numbers of entries in the log file. If the actual
; number exceeds this value, the server starts to override old entries
; (principle: ring buffer)
; Mode of alarm protocol writing
; if a number of less than -1 is specified, this number of protocol files is
; parallely held, and one of them is actually used
; if a number of -1 is specified, the protocol-file is not automatically updated
; if 0 is specified the protocol file is immediately updated
; if a number above 0 is specified, the protocol file is updated after the
; specified number of seconds elapsed with no intermediate alarm state
; changes. t he protocol-file is always updated when you send the
; DDE-Command: "AlarmProt" to the MBDDE-server
; (principle: ring buffer) ---------------------------------------------------------------
# attention: the mode changed from V4 to V5 !
Mise en service HMI Advanced (IM4)
2 Fonctions / paramétrage
IM4/2-97