Krick ro marin Dusseldorf Mode D'emploi page 62

All information on recommended accessories is based on the technical status as of Winter 2020. Subject to
technical changes.
The electronic modules are fixed with double-sided adhesive tape. Wiring must be carried out in such a way
that all cables of the modules installed in the cabin structure can be separated from the RC plate by reverse
polarity protected plug connections. It is also recommended that the plugs for the receiver and the sockets
for the decoders are provided with small flags and labeled with the insertion position.
Before inserting the RC unit into the boat, glue in the frame parts (302) and (303) for holding the drive
batteries. If you use the proposed two batteries (282) 6 V / 12 Ah, take the installation dimensions directly
from the plan. If you use other batteries, move them in such a way that the water position of the boat is
maintained. Adapt the transverse strip (302) to the hull cross-section and glue it in place with acrylite so that
the battery is close to the motors. Adjust and glue in the longitudinal strips (303) so that the batteries are to
the right and left of the keel. The sockets for connecting the cables are facing each other. (Remove the drive
batteries). Insert the complete RC unit into the boat and glue it together.
Now the final lengths of all cable connections can be determined and the corresponding connectors for
26 © Klaus Krick Modelltechnik, Knittlingen, Germany Status 08/2022