Krick ro marin Dusseldorf Mode D'emploi page 49

stand (94) with reinforcement strip (93) into the larger slot.
Suppress the gear motor (95) (reduction 400:1) and solder about 300 mm of cable.
Then screw the motor (95) to the motor stand using M 1.6 screws.
Ream the washers (96) and (97) with Ø 3 mm. Place one large and one small disc each on the Ø 3 mm axle
(102) and glue them together to form stepped discs. Glue the driver plate (98) twice to one disc on the small
disc (97). Drill 3 mm Ø into the plastic tube (99) for the threaded pin of the adjusting ring (101) and 1.5 mm Ø
for the split pin (100), insert the split pin (100), shortened to about 10 mm, bend it apart inside and glue it
together.
Notes on fire-fighting monitors.
Assembling the monitors is not particularly difficult, but since they cannot be retrofitted for special functions, it
should be determined before which of the possible functions are to be carried out.
It is shown and described:
Function 1: Proportionally controlled, horizontal pivoting with the aid of a normal servo
(pivoting range of the monitors: 270°)
Function 2: Proportionally controlled lifting and lowering of the extinguishing pipes with another, normal
servo.
Function 3: Connecting an extinguishing water pump.
It is recommended to paint the handwheels and straightening levers before assembling. The instructions and
the plan explain the fully equipped monitors.
Monitor A
At the beginning the grating for all three monitors are built and painted together. Remove the grating frames
(106) for monitor "A", (107) for monitor "B" and (108) for monitor "C" from the laser parts and grind them
cleanly. Paint the part (106) red, the parts (107) and (108) beige. The frames contain markings for the
position of the innermost strips.
The 1.5 x 5 mm linden strips (109) are first primed twice.
© Krick Modelltechnik, Knittlingen, Germany
Now glue the step pulleys with inserted adjusting
ring (103) and the tube at right angles to the drum.
Then mount the unit with the Ø 3 mm brass axis
(102) between the base plates (92). Cleanly align
the winch unit, check that it runs smoothly and
connect the motor support to the geared motor (95)
and coupling hose (95a).
(Disassembly: Loosen the adjusting ring, pull out the
shaft (102) and remove it from the motor).
The sash fastener (104) with the Ø 2.2 x 6.5 mm,
self-tapping screw (105) is fitted in the reinforcement
strip (93) for securing. A corresponding slot is
provided in the base plate (88). The winch is now
complete and can be installed in the hull. It is
recommended that the base plate with the frame is
glued in on its own (acrylite) and the winch is
inserted later. Separate 10 cm from the chain for the
fixed anchor side. Thread the long chain piece on
the functional side according to the plan and fasten
it to the anchor and winch.
The electrical connection to the RC system is made
later.
13