Krick ro marin Dusseldorf Mode D'emploi page 53

Set the extinguishing heads "B" and "C" so that the servo swivels them evenly and together to the left and
right.
Place the lift lever (138) on the servo disk of the lift servo (134) and screw in the clamping screws Ø 2.2 x 6.5
mm (129) with washers (130). Attach the tube rivets Ø 8 x 8 (118) to the monitor shafts (Mo4) so that the
nylon thread (Mo22) does not rub against the tubes. Then thread the yarn from both monitors according to
the drawing in the lever, the extinguishing heads are in the highest position and move the servo to the
corresponding position. Carefully clamp the nylon threads and move the servo to the "low" position,
observing the erasing heads. When correctly arranged, the pipes swivel together from the highest to the
lowest position. If everything works, the lifting lever and servo disk are glued and secured with the fourth
screw (129). The monitors "B" and "C" can also be moved.
The connection to the pump is made later.
Now completely disassemble the monitors "B" and "C" so that they are not damaged during further
assembly. The grating "B" is screwed back onto the cabin to prepare the circular handrail.
Handrails and cabin rails
If necessary, the retaining straps on the grating "B" are drilled out to Ø 2 mm.
Now drill carefully, exactly vertically, into the cabin roof. The supports (139) are first sawn off from Ø 2 mm
brass-tube with overlength. Then insert the supports into the grating and roof.
To make the grating even, it is aligned as shown in the photo, using a ruler. Now adjust all supports to a
height of 33 mm (height corresponds to the inserted railing support). Do not stick supports together.
65 mm
Cut the 2 handrails (140) to 350 mm length and then bend them in one plane according to the photo (I.).
134
133
119
50 mm
© Krick Modelltechnik, Knittlingen, Germany
132
Mo1
116
137
17