Krick ro marin Dusseldorf Mode D'emploi page 47

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

59
Then cut out the valve housings (57) according to the marking and cleanly grind the cut edges.
Place the enclosures in the cabin according to plan, cut AA, detail X and glue together. Grind the recesses in
the cabin flush with the inner surfaces of the valve housings.
If everything is well finished, the cabin can be pushed over the coaming with slight pressure. If necessary,
minor reworking should be carried out now.
If the cabin is seated correctly, mark the position of the frame arch (59) on the inside of the front deck by
transferring the inner contour of the frame to the front deck through the cabin ceiling.
Glue the holding block (60) to this mark according to the plan. This means that the cabin can no longer be
moved backwards. Cut the 8 x 5 mm support strips (61) to length according to the plan, prime and glue them
in place with acrylite according to the sectional drawing. Accordingly, the cross supports (62) must be cut
from 5 x 8 plywood strips, fitted free of tension and glued in place, unless special functional installation is
provided.
The ABS laser parts of the doors (63), (64) and (67) as well as the hatches (65) and (66) are machined and
adapted to the intended positions. We recommend that all doors are not glued on until the body and the
doors themselves have been individually painted.
At the end of this step, glue on the panels (68). The cabin roof (69) is cut out, neatly aligned and glued with
acrylite at the edges of the cabin ceiling. Now the shell of the model is finished and.
69
56
62
58
58
© Krick Modelltechnik, Knittlingen, Germany
61
It is recommended to make the other assemblies and
the small parts of the boat, to adapt them to the body or
hull and to drill the corresponding holes. However, do
not install these parts firmly yet - this only happens after
painting. In this way you save yourself the tedious task
of masking before painting. Before painting, make sure
that the masking films of the windows are pressed well
on their edges again so that no paint can creep under
them.
57
11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ro1100Romarin ro1100Romarin ro1101Romarin ro1103

Table des Matières