Krick ro marin Dusseldorf Mode D'emploi page 38

Suitable remote control systems:
All remote control systems with two channels or more are sufficient for pure driving operation with the
functions forward/backward and steering.
For upgrading the model with special functions, we recommend a remote control with 14 channels or more.
Please contact your dealer or www.krick-modell.de for information about the current product range.
Accessories not included but required for driving operation to build the model:
piece. Description
2 Geared motor Max Gear 2.5:1
2 Interference suppression filter
2 Shaft coupling
1 Steering servo
2 drive battery, 6 V / 7Ah or 12 Ah
1 speed controller, from 30 A
1 Receiver
1 Silicone cable 2-pole 1.5 mm²
1 Motor connection Plug+socket round
1 plug/socket Faston 6.3 mm insulated
1 Tam. Plug connection socket/plug
Fitting set (BS), order no. ro1101
Contains all necessary small parts to decorate the model; e.g. fans, stairs, towing gear, life rings, lamps,
metal anchors, railing supports, signal horn.
Special function set (SFS), order no. ro1103
This set contains all the parts needed to install the special functions shown in the construction plans. For
example, the following functions are possible with these parts. Proportional horizontal and vertical pivoting of
the monitors. Connecting a fire pump, moving the boat crane, light bulbs to illuminate all lamps on board, etc.
Further accessories required for expanding the special functions can be found in
the information sheet included in the kit.
Please follow the instructions of the individual devices carefully!
Due to technical changes, construction steps in the instructions may differ from the delivered contents of the
construction kit. If you are unsure, please refer to the German instructions.
2 © Klaus Krick Modelltechnik, Knittlingen, Germany
Part No.
18f
21
18e
26
282
283
284
163
---
---
---
Order No.
42275
42128
rb106-65
79059
667255 or 667256
67053
67537
67521
ro4039
67513
Status 08/2022