well as the tightness of the water-carrying parts. Screw the M 2 x 4 screws Mo16 into the outriggers.
The transverse bearing (Mo17) from the Ø 2.5 x 8 mm brass sleeve is drilled through Ø 1.5 mm transversely.
Now cut the setting lever (Mo18) from Ø1 mm brass wire to 90 mm and form the hook according to plan.
Hook the setting lever onto the knee of the pipe support (Mo7) and fit the cross bearing and tupe (Mo19).
Then hang the cross bearings between the outriggers.
Bend the rear eye of the tension spring (Mo20) so that it can be pushed over the setting lever (Mo18) as
shown in the drawing, hang the front eye in the hook of (Mo18).
When in perfect working order, the quenching head always lifts to the position of the highest pipe elevation.
Drill the Ø 7 mm handwheel (Mo21) in the middle Ø 1 mm and slide it onto the end of the setting lever. If the
height adjustment is to work, the Ø 0.25 mm Perlon thread (Mo22) (500 mm long) is clamped with the small
handwheel and threaded through the thin brass tube (Mo5). Now swivel the erase head to the lowest
position and advance the handwheel (Mo21) to the end of the tube (Mo19).
Shorten the protruding setting lever. The erase head "A" can now be checked manually for all movement
functions.
The handwheel (Mo23) as well as the valve lever (Mo24) will be used later.
Make sure that everything can be moved easily.
The extinguish heads for the monitors "B" and "C" are assembled in the same way. Only the lengths of the
following parts must be observed:
Monitor shaft B (Mo4) = 175 mm long Guide tube B (Mo5) = 180 mm long
Monitor shaft C (Mo4) = 125 mm long Guide tube C (Mo5) = 130 mm long
Function upgrade for monitor A
125
Mo22
Mo15
Mo4
116
the swivel servo and (114) for the lift servo and the
spacer plates (115). According to plan, glue parts 113-
115 on a flat surface to a right-angled frame (UHU hard).
Glue the servo frames 120 and 125 together from their
115
respective parts a, b and c according to the illustration
and glue them flush with the upper edge to the plates
(113) and (114).
Insert the erasing head "A" into the foot Mo2 on the cover
52 and align the primed frame with bearing bush Mo1
according to the monitor shaft Mo4.
© Krick Modelltechnik, Knittlingen, Germany
Detach and assemble the two servo mounts (113) for
127
118
119
15