Preliminary Work - Krick ro marin Dusseldorf Mode D'emploi

General information for the construction process:
The numbering of the individual components essentially corresponds to the assembly described in the
instructions. Before starting construction, please read the entire construction manual in conjunction with the
construction plans with the utmost care.
Use the parts list and the plans to get an exact overview of the various components and the construction
process. With the photos inserted in the text we give you information about the current state of assembly.
Parts or assemblies are partly unpainted for a better overview.
The installation of the respective special function is described at the corresponding point. However, this can
also be retrofitted.

Preliminary work:

Before starting work, check the completeness of the individual parts that are indicated as belonging to the
assembly.
Carefully cut laser parts out of the laser sheets with a sharp knife, deburr and re-drill holes if necessary. All
wooden parts must be sanded, especially at the edges, and primed two to three times with a pore filler
before installation or attachment.
Grinding work on ABS parts or on cut edges of glued together ABS parts must be carried out with fine wet
paper. All areas on ABS parts where bonding is carried out must be roughened up before with coarse
abrasive paper.
Boat stand:
The first step is to build the boat stand so that your model boat has a secure hold on the worktable. First
release the side parts (A) and support plates at the front (B) and rear (C) from the laser sheet.
The boat stand can now be assembled and the support can be covered with felt or foam to protect the hull
surface.
B
A
A
C
The hull assembly
Hull:
The hull (1) made of ABS is roughly worked out with a knife or a fine jigsaw towards the contours visible on
the inside. Then use a file, planer or balsa knife and sandpaper to finish the contour of the hull exactly to the
mark so that no more bulges remain on the outside. (Section B-B, View Y).
1
4 © Klaus Krick Modelltechnik, Knittlingen, Germany Status 08/2022