Krick ro marin Dusseldorf Mode D'emploi page 60

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

RC intallation with all special functions
The instructions of the individual devices must be strictly observed. All functions are shown schematically in
the enclosed circuit diagram.
For the fire-fighting boat "DÜSSELDORF", for example, the 14-channel Multi Pro LCD remote control with
item no. 79010 is required. If all the suggested special functions are to be installed, a remote control with at
least 14 slots on the receiver for servos and electronic modules is recommended. Due to the many special
functions, the installation of a separate receiver battery is recommended.
First assemble the plywood housing for the RC system and batteries for the special functions.
Glue the side panels (288) to the base plate (287a) so that the two lead batteries (289) (6 V / 1.3 Ah) can be
easily inserted without slipping. Then place the RC plate 290 and glue it on. Select a suitable location for the
speed controller and receiver and secure with double-sided adhesive tape. Optionally, mount a frame (291)
made of pine strips 5 x 5 mm.
The following special functions are planned for Düsseldorf.
Special function
Turn extinguishing monitor A:
Raise extinguishing monitor A:
Lift extinguishing monitor B+C:
Turn extinguishing monitor B+C:
Raising/lowering crane:
Turning the crane r/l:
Anchor winch lift/lower:
Blue light flashes:
Pump on/off:
Turn the headlights:
Turn radar on/off:
Position light r/l/m/v/h on/off:
Headlights on/off:
Anchor light on/off:
Towing light on/off:
Exemplary assignment of the individual channels for a 14-channel receiver. If a receiver with fewer channels
is to be used, a Quadro Switch Module can be used instead of 2 Duo Switch modules. This reduces the
number of channels required to 13.
Special function
CH 1
Proportional channel
CH 2
Proportional channel
CH 3
Proportional channel
CH 4
Proportional channel
CH 5
3-step switch
CH 6
3-step switch
CH 7
Turn proportional channel
CH 8
Turn proportional channel
CH 9
3-step switch
CH 10 3-step switch
CH 11 3-step switch
CH 12 3-step push
CH 13 3-step push
CH 14 3-step push
Bat
Powerpack 4.8V/6V receiver power supply 285 and switch cable 286
(V-cable part no. 79014 may be required).
24
Required accessories
Servo
Servo
Servo
Servo
Mikrospeed 1
Mikrospeed 1
Mikrospeed 1
RC module flash
Uno Switch
Duo Switch or Quadro Switch
Duo Switch or Quadro Switch
Duo Switch or Quadro Switch
Duo Switch or Quadro Switch
Duo Switch or Quadro Switch
Duo Switch or Quadro Switch
Required accessories
steering servo
speed controller
servo extinguishing monitor A lift
lift servo extinguishing monitor B+C + release towing hook
lift/lower crane
turn crane r/l
servo extinguishing monitor A
servo extinguishing monitor B+C
pump on/off
flash module blue light
anchor raise/lower
button turn radar on/off + position light r/l/m/v/h on/off
button towing light on/off + anchor light on/off
button spotlight turn + spotlight on/off
© Klaus Krick Modelltechnik, Knittlingen, Germany
Status 08/2022

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ro1100Romarin ro1100Romarin ro1101Romarin ro1103

Table des Matières