In The Alarm Output "Off"  Configuration Setting; Connector Assignments Of Slot Iv, Diaphragm Breakage Monitoring - Ecolab Elados EMP III E60 Mode D'emploi

7.2.5.3.1 In the alarm output "ON" ⚫ configuration setting
(see menu description in chapter
Jumper
Closing function:
(Default setting)
Opening function:
7.2.5.3.2 In the alarm output "OFF"  configuration setting
(see menu description in chapter
Jumper
Closing function:
(Default setting)
Opening function:
* fail-safe function, (safe in the event of failure)
7.2.6

Connector assignments of slot IV, diaphragm breakage monitoring

417101441_EMP_III_E60.docx
10.3.9 "Configuration / Alarm output")
If "No Alarm"
(Alarm relay has not
pulled in)
contact open
contact closed
10.3.9 "Configuration / Alarm output")
If "No Alarm"
(Alarm relay has (Alarm relay has not
pulled in)
contact closed
contact open
3 + 4
PIN
3
4
1 + 3 +
PIN
1
3
4
Fig. 7.28 Connector assignments of slot IV, diaphragm breakage monitoring
- 90 -
If "Alarm"
(Alarm relay has (Alarm relay has not
pulled in)
contact closed
contact open contact closed
If "Alarm"
(Alarm relay has
pulled in)
contact open contact open *
contact closed contact closed
= Input diaphragm breakage
monitoring with potential free
contact
Assignment
Relay output
GND (┴)
4 = Input diaphragm breakage
monitoring with electronic switch
(NPN)
Assignment
5 V, DC
Relay output
GND (┴)
Power Off
pulled in)
contact open
Power Off
pulled in)
Rev. 13-10.19