Metering Monitoring / Input (Only At E60 Without Dongle Box); Oval Gear Meter Pulse Display; Plus; Configuration / Batch - Ecolab Elados EMP III E60 Mode D'emploi

10.3.13.5 Metering monitoring / Input (only at E60 WITHOUT
The "Input" setting is used to determine which input (pulse input or metering lock) at plug II
(or at plug V if a
pulses from the metering monitoring unit.
The flow monitor connection depends on the selected input:
This function can only be selected if no dongle box is connected.
NOTE
In this case, the original function (e.g. pulse input) can no longer be used.
10.3.13.6 Oval gear meter pulse display (only
Fig. 10.39 Display of the oval gear meter pulse (only E60

10.3.14 Configuration / Batch

The pump must be calibrated before using batch metering (see chapter
NOTE
"Calibration").
When activating batch mode with a signal to the metering lock/pulse input (plug II) (or at
plug VII if a dongle box is used) pin
previously defined quantity is metered with 100 % stroke frequency (assortment of inputs
see chapter 10.3.14.3
connection see chapter
batch pulse").
The batch metering can be interrupted by deactivating the release (metering lock) or
switching off the pump.
10.3.14.1

Selecting

417101441_EMP_III_E60.docx
dongle-box is used) of the pump should be used to evaluate the incoming
This display shows the number of pulses recorded during the last
calibration process (running time during calibration = 1 min).
If the value shown is less than 60, metering monitoring using an oval
gear meter is only possible to a limited extent.

PLUS

)
2+4
"Batch / Input (only at
7.2.4.4 "Installing the batch function" and
Dongle
Input pulse:
plug II Pin
Input metering lock:
plug II Pin
see chapter
metering monitoring"
Fig. 10.38 Metering monitoring / Input
(only at E60 WITHOUT dongle box
E60 )
PLUS
(input pulse) or pin 3+4
E60 WITHOUT Dongle box)",electrical
Fig. 10.40 Configuration / Batch: Selecting
-
✓
If batch metering is active, the
following items appear in the
submenu:
Menu item
• Quantity
• Input
- 112 -
box)
2+4 (or plug V)
3+4 (or plug V)
„Installing the
7.2.4.5
10.4
(input metering lock), a
8.2.2.1 "Installing the
Batch is inactive
(Default setting)
Batch is active
see chapter
10.3.14.2
10.3.14.3
Rev. 13-10.19