Batch / Input (Only At E60 Without Dongle Box); Display In The Operating Display; Calibration; Overview - Ecolab Elados EMP III E60 Mode D'emploi

10.3.14.3 Batch / Input (only at
The "Input" setting is used to determine which input (pulse input or metering lock) at plug II
(or plug VII if a dongle box is used) of the pump should be used to evaluate the start pulse
for the batch metering. The start pulse cable connection depends on the selected input:
In this case, the original function (e.g. pulse) can no longer be used.
NOTE
When using a dongle box, a separate input is available.
10.3.14.4

Display in the operating display

Fig. 10.43 Configuration Display in the operating display
10.4

Calibration

10.4.1

Overview

The procedure and display during the calibration process differ depending on whether or not
an oval gear meter is connected.
Fig. 10.44 Calibration Overview
10.4.2

Calibration pump

The specified metering capacities in metering pumps are always determined under ideal
conditions (metering of water at 20 °C, short suction and metering pipes, rated back-
pressure, no pressure-boosting valves in the metering line).
As these conditions never occur in practice, you are advised to calibrate the actual metering
rate of the metering pump under prevailing local conditions.
417101441_EMP_III_E60.docx
E60 WITHOUT Dongle box)
Input pulse:
plug II (or plug VII) Pin
Input metering lock:
plug II (or plug VII) Pin
see chapter
chapter
Default setting = Metering lock
Fig. 10.42 Configuration Batch / Input (only at E60 WITHOUT Dongle-box)
Pos. Description
1
Operation mode
2 Quantity remaining to be metered
3 Strokes remaining to be executed
2+4
3+4
7.2.4.4 "Installing the batch function" and
8.2.2.1 "Installing the batch pulse ".
Calibration pump:
• see chapter
Calibration pump with oval gear
meter:
• see chapter
- 114 -
10.4.2
10.4.3
Rev. 13-10.19