Selecting; Display In The Operating Display/ Setting; Operation Mode / Current (External Standard Signal) - Ecolab Elados EMP III E60 Mode D'emploi

10.2.3.1 Selecting

10.2.3.2 Display in the operating display/ Setting

Fig. 10.9 Display inthe operating display / Setting. Multiplication
The multiplication and division factors are configured / adjusted in the operating display.
This can take place while the pump is operating.
If the newly set value is not confirmed within 10 seconds by pressing the START/STOP
NOTE
key, the system reverts to the previously set running value.
10.2.4

Operation mode / current (external standard signal)

In the "current" operation mode, the pump functions on the basis of an incoming standard
signal. The incoming signal (0/4-20 mA; 20-0/4 mA or adjustable) is converted into a
metering frequency 0-100 % (stroke/pause ratio), e.g.:
The following operating options can be selected:
• 0 – 20 mA
• 4 – 20 mA
• 20 – 0 mA
• 20 – 4 mA
• User defined
417101441_EMP_III_E60.docx
Multiplication
0 mA = 0% metering frequency, 20 mA = 100 % metering frequency
4 mA = 0% metering frequency, 20 mA = 100 % metering frequency
20 mA = 0% metering frequency, 0 mA = 100 % metering frequency
20 mA = 0% metering frequency, 4 mA = 100 % metering frequency
n (adjustable) mA = 0 % metering frequency,
n (adjustable) mA = 100 % metering frequency
Fig. 10.8 Operating mode / pulse: Selecting
Fig. 10.10 Display inthe operating display / Setting: Division
- 102 -
Division
Rev. 13-10.19