Delivery Condition; Basic Setting Of The Mode Of Operation / Display In The Operating Display; Operating State; Basic Settings In The Configuration - Ecolab Elados EMP III E60 Mode D'emploi

9.7

Delivery condition

9.7.1

Basic setting of the mode of operation / display in the operating display

Fig. 9.8 Basic setting of the mode of operation / display in the operating display
NOTE
With each stroke of the pump, the indicator in the upper right of the display
9.7.2

Basic settings in the configuration

The following factory settings are defined in the configuration.
Fig. 9.9 Basic settings in the configuration
417101441_EMP_III_E60.docx
Operating mode:
Metering frequency / - quantity: strokes / min (122 strokes / min at 50 Hz,

Operating state:

internal
146 H strokes / min at 60 Hz)
OFF (at V 4.1, „Standby" at V4.0)
(to start the pump press START / STOP key)
Configuration of
language:
unit:
code:
auto start:
metering lock:
low level contact:
alarm output:
pulse memory:
oval gear meter:
metering controler:
meter monitor:
batch:
- 98 -
rotates 1 turn.
Standard see chapter
german 10.3.3
liter 10.3.4
not active (-) 10.3.5
not active (-) 10.3.6
not active (-) 10.3.7
open () 10.3.8
off (⚫) 10.3.9
not active (-) 10.3.10
not active (-) 10.3.11
not active (-) 10.3.12
not active (-) 10.3.13
not active (-) 10.3.14
Rev. 13-10.19