Metering Monitoring / Input (Only At E60 Without Dongle Box); Oval Gear Meter Pulse Display (Only E60 Plus ); Configuration / Microflow - Ecolab Elados EMP II E60 Mode D'emploi

10.3.13.5 Metering monitoring / Input (only at E60 WITHOUT Dongle box)

The "Input" setting is used to determine which input (pulse input or metering lock) at plug II
(or at plug V if a dongle-box is used) of the pump should be used to evaluate the incoming
pulses from the metering monitoring unit.
The flow monitor connection depends on the selected input:
Input pulse:
Input metering lock:
NOTE
10.3.13.6 Oval gear meter pulse display (only
Fig. 10.39 Display of the oval gear meter pulse (only E60
10.3.14 Configuration /
Micro Flow PLUS
(Art. No. 288413, EBS No. 10005481), a connecting cable (Art. No. 284412,
EBS No. on request) and an analysis box (Art. No. 248611, EBS No. on request).
Once the MicroFlow box
the pump off and then on again, "E60+microflow" appears on the bottom left of the pump's
display unit, and the menu option Dosage Monitoring is automatically replaced by the
MicroFlow function with the appropriate sub-menu under Configuration in the Pump menu.
If the pump software recognises that there is a
communication is then interrupted between the pump and the MicroFlow (through the
removal of the
(refer to chapter 12.2).
NOTE
417101438_EMP_II_E60
= plug II Pin
= plug II Pin
This function can only be selected if no dongle box is connected.
In this case, the original function (e.g. pulse input) can no longer be used.
This display shows the number of pulses recorded during the last
calibration process (running time during calibration = 1 min).
If the value shown is less than 60, metering monitoring using an
oval gear meter is only possible to a limited extent.
PLUS
MicroFlow PLUS
is a system for monitoring the dosing rate. It consists of a flow rate sensor
has been connected (see chapter 8.1) and is activated by switching
MicroFlow box, for example), an error message is displayed
Please refer to the relevant operating instructions (Art. No. 417101314, EBS No. on request)
when installing / commissioning the
The standard settings saved for "Strokes", "Deviation", "Metering break" and "Metering
delay" may only be viewed as defaults.
Depending on the design of the system, the sensitivity of the MicroFlow system
(for instance, type of chemicals, metering rate, cross-sections, line lengths...) must be
adapted individually to the local conditions by modifying the parameters mentioned above.
2+4 (or plug V)
see chapter
3+4 (or plug V)
E60 )
PLUS
)
MicroFlow box
MicroFlow
PLUS
- 113 -
.
7.2.3.5
Fig. 10.38 Metering monitoring / Input
(only at E60 WITHOUT dongle box
connected, and the
dosage monitoring system.
Rev. 12-01.19