In The Alarm Output "On" ⚫ Configuration Setting; Power Off; In The Alarm Output "Off"  Configuration Setting; Connector Assignments Of Slot Iv, Mains Power Supply - Ecolab Elados EMP II E60 Mode D'emploi

7.2.4.4 In the alarm output "ON" ⚫ configuration setting
(see Menu Description in chapter
Jumper
Closing function:
(Default setting)
Opening function:
7.2.4.5 In the alarm output "OFF"  configuration setting
(see Menu Description in chapter
Jumper
Closing function:
(Default setting)
Opening function:
* fail-safe function, (safe in the event of failure)
7.2.5

Connector assignments of slot IV, mains power supply

Fig. 7.24 Connector assignments of slot IV, mains
power supply
To ensure the imperviousness of the mains power connection to humidity, the gasket
NOTE
(contained in the delivery scope and already built-in in the as-delivered condition) must be
inserted and the fixing screw tightened into the middle of the plug.
 Connect the mains power supply cable to the power grid.
417101438_EMP_II_E60
10.3.9 "Configuration / Alarm output")
If "No Alarm"
(Alarm relay has not
pulled in)
contact open
contact closed
10.3.9 "Configuration / Alarm output")
If "No Alarm"
(Alarm relay has
pulled in)
contact closed
contact open
The mains power supply enters through a four-terminal frontal
plug connector. This already has a plug screwed into it in the
factory.
Conductor coloring
Pin
(cable connection)
L1 black
N blue
PE yellow / green
* -
- 91 -
If "Alarm"
(Alarm relay has (Alarm relay has not
pulled in)
contact closed
contact open
If "Alarm"
(Alarm relay has not
pulled in)
contact open
contact closed
Assignment
Mains / external conductor
Neutral wire
Protective earth wire
Not assigned

Power Off

pulled in)
contact open
contact closed
Power Off
(Alarm relay has
pulled in)
contact open *
contact closed
Rev. 12-01.19