In-/ And Output Circuit; Connector I; Connector Ii - Ecolab Elados EMP II E60 Mode D'emploi

14.3.4

In-/ and output circuit

14.3.4.1

Connector I

input
empty report
reserve
Fig. 14.3 Connector I
14.3.4.2

Connector II

input
pulse
metering lock/
batch/ metering
monitoring
standard signal
output
Fig. 14.4 Connector
II
external
power supply
14.3.4.3 Connector III
output
empty/reserve/
fault report
stroke signal
Fig. 14.5 Connector
III
417101438_EMP_II_E60
allocation external circuit
1 (brown)
+
4 (black)
voltage-free contact
3 (blue)
Warning: do not connect any external voltages!
+
4 (black)
allocation external circuit
2 (white)
+
voltage-free contact
4 (black)
Note: do not connect any
3 (blue)
external voltages!
+
4 (black)
5 (grey) external current
+ Note: Observe polarity of the
connected signal!
4 (black)
allocation external circuit
1 (brown) voltage-free contact
+ Note: do not connect any
4 (black) external voltages!
allocation external circuit
1 (brown)
+ external current
2 (white)
external current
3 (blue)
+ Note:
4 (black) Observe the polarity of the
connected signal!
- 138 -
declaration of value
minimum power-on and power-off time
15 ms
0/4-20 mA,
load approx. 50 ohm
declaration of value
Power supply for ext. devices
Outputs: 5VDC; max. 50mA
declaration of value
max. external volt. 230 VAC/DC
max. 3 A
with reserve report:
contact approx. 500 ms closed
contact approx. 500 ms opened
max. external voltage 24 V DC,
max 0,3 A
when stationary: Contact open
at 50 Hz mains power:
at 100 % run:
contact approx. 310 ms closed
contact approx. 180 ms opened
at 50 % run:
contact approx. 310 ms closed
contact approx. 660 ms opened
at 60 Hz mains power:
at 100 % run:
contact approx. 260 ms closed
contact approx. 150 ms opened
at 50 % run:
contact approx. 260 ms closed
contact approx. 550 ms opened
Rev. 12-01.19