Flap Servo Installation - Horizon Hobby Hangar 9 Ki-43 Oscar 60cc Manuel D'utilisation

11. Fit the fl ap to the wing. Check that the fl ap can move freely, and the
hinges are all aligned properly. Use low-tack tape to hold the fl ap in
position until the epoxy fully cures.
12. Use a paper towel and isopropyl alcohol to remove any excess epoxy
before it can fully cure. Use care not to get epoxy in the moving part
of the hinge or between the fl ap and wing. Continue once the epoxy
has fully cured for both sets of fl ap hinges.
 Make sure to check that the flap hinges are glued
securely once the adhesive has fully cured.
 Repeat this section for the remaining flap hinge installation.
Ki-43 Oscar 60cc ARF

FLAP SERVO INSTALLATION

1. Center the fl ap servo. Attach the servo horn on the servo
perpendicular to the servo centerline.
 We recommend setting the throws to 0% for radios
using a three-position switch to prevent damaging the
servo if the linkage is not the correct length.
2. When attaching the linkage to the aileron servo arm, use the hole in
the arm that is 5/8-inch (16mm) from the center of the arm.
3. Prepare both the left and right fl ap servos at this time.
4. Assemble the linkage for the fl ap using two ball ends and the 4
inch (120mm) threaded rod. Thread each ball end 12 turns on
the link. Adjust the length so the distance between the ball ends
1
measures 4 / inches (108mm).
4
5. Remove the servo arm from the servo. Secure the servo ball link
to the servo arm using an M3 x 10 button head screw, M3 washer
and M3 lock nut. Use a 2.5mm hex wrench and 5.5mm nut driver to
tighten the hardware.
15
5/8 inch
(16mm)
23 /
32
EN