Aileron Servo Installation - Horizon Hobby Hangar 9 Ki-43 Oscar 60cc Manuel D'utilisation

11. Once the epoxy has fully cured, pull on the wing and aileron to make
sure the hinges are glued securely. If not, remove the aileron and
sand off any adhesives. Repeat this section to glue the hinges.
EN

AILERON SERVO INSTALLATION

1. Use a hobby knife and #11 blade to remove the covering for the
aileron pushrod exit.
2. Center the aileron servo. Attach the servo horn on the servo
perpendicular to the servo centerline.
3. When attaching the linkage to the aileron servo arm, use the hole in
the arm that is 5/8-inch (16mm) from the center of the arm.
4. Prepare both the left and right aileron servos at this time.
5. Assemble the linkage for the aileron using two ball ends and the
15
3 / inch (100mm) threaded rod. Thread each ball end 12 turns
16
on the link. Adjust the length so the distance between the ball ends
5
measures 3 / inches (80mm).
32
12
5/8 inch
(16mm)