Receiver Installation; Cowling And Spinner Installation - Horizon Hobby Hangar 9 Ki-43 Oscar 60cc Manuel D'utilisation

RECEIVER INSTALLATION

1. Install the receiver in the fuselage. Secure the receiver using the
methods included in the receiver or radio instructions.
2. Mount any remote receivers in the fuselage using hook and loop
tape. Use the instructions provided with the receiver to orient the
remote receivers in the fuselage for the optimum operation of the
receiver.
 Apply a small amount of 5-minute epoxy to the hook
and loop tape to secure them in the fuselage.
EN

COWLING AND SPINNER INSTALLATION

 The spinner cone has been prepared with the slots for the propeller.
Most engines of this size use four bolts to retain the propeller.
Careful positioning of the drilled holes is required to make sure
the propeller aligns with the cutouts in the spinner cone.
 We recommend preparing at least two propellers in case
a new propeller is required when out flying the model.
1. Place the washer from the engine on the spinner backplate. Mark
the locations for the propeller mounting screws using a felt-tipped
pen.
2. Remove the washer from the backplate. Use a drill and 7/32-inch
(5mm) drill bit to drill the holes for the propeller mounting screws.
 A drill press is highly recommended for drilling
the holes to guarantee the holes are properly
aligned when installing the propeller.
3. Use a stepped reamer or bolt through the spinner back plate and
propeller to hold them in alignment so the bolt holes for attaching
the propeller can be marked.
4. Use the four M3 x 10 socket head cap screws to secure the spinner
cone to the back plate. Use a 3mm hex wrench to tighten the
screws. Position the propeller so it does not contact the spinner
cone. Use a pin vise and 3/16-inch (4.5mm) drill bit to drill and
indent or marker for the mounting bolt locations.
 It may be necessary to trim the spinner cone to clear
the propeller depending on the choice of propellers.
32