Horizon Hobby Hangar 9 Ki-43 Oscar 60cc Manuel D'utilisation page 16

6. The ball link will be attached to the underside of the servo arm as
shown.
7. Install the fl ap servo in the wing with the output facing the leading
edge. Make sure to prepare the servo mounting holes by threading
a servo mounting screw into each hole and removing them. Harden
the mounting screw locations with thin CA before installing the
servo.
 The flap servos can be positioned in the wing to allow the
use of a Y-harness to connect the servos to the receiver.
8. Secure the servo ball link to the control horn using an M3 x 10
button head screw, M3 washer and M3 lock nut. Use a 2.5mm hex
wrench and 5.5mm nut driver to tighten the hardware.
9. Attach the servo arm to the servo.
10. Adjust the length of the linkage to position the fl ap in the mid fl ap
position of 1–1 3 / inches (25–30mm).
16
 Remember to set the throws to 0% in both the up and down
positions to prevent damage to the servo, flap or linkage.
EN
11. Move the servo to the UP fl ap position using the radio system. Adjust
the throws at the radio system to bring the fl ap in alignment with the
bottom of the wing.
12. Move the servo to the FULL fl ap position of
(50–60mm) using the radio system. Adjust the throws in the radio
system to obtain the measurements listed.
13. The linkage may rub against the wing structure depending on servo
selection. Use a hobby knife with a #11 blade or a rotary tool and
sanding drum to trim the wing structure as necessary to clear the
linkage.
16
1 31 / –2 3 / inches
32 8