Horizon Hobby Hangar 9 Ki-43 Oscar 60cc Manuel D'utilisation page 26

5. Attach your motor to the fi rewall using the aluminum standoffs
and screws. Use a drop of threadlock on each screw to prevent
them from vibrating loose. Connect the leads between the speed
control and motor. Secure the leads so they don't interfere with the
operation of the motor.
6. Secure the battery for the radio system in the lower section of the
fuselage. Use hook and loop tape and hook and loop straps to keep
the battery secure.
7. Apply a thin layer of 5-minute epoxy to the battery tray where the
hook and loop will be attached. Allow the epoxy to fully cure before
applying hook and loop tape to the battery tray.
 The adhesive on the hook and loop tape will not
adhere to the raw wood. Using epoxy creates a
surface suitable for the hook and loop adhesive.
8. Apply the mating hook and loop tape to the batteries.
 Do not cover safety warnings on the
battery with hook and loop tape.
9. Use hook and loop straps around the battery tray to secure the
batteries to the tray.
 Apply a small amount of 5-minute epoxy to the straps to
secure them to the battery tray. This will prevent them from
falling through the holes when the battery is removed.
EN
10. Prepare and harden the holes in the fuselage for the battery tray
screws using an M3 x 15 sheet metal screw and thin CA. Secure the
battery tray in the fuselage using four M3 x 15 sheet metal screws
and four M3 washers.
11. Secure the batteries in the fuselage using the hook and loop straps.
The position of the batteries can be moved to help balance the
model.
26