Tail Wheel Installation - Horizon Hobby Hangar 9 Ki-43 Oscar 60cc Manuel D'utilisation

6. Attach a ball end, and the two ball ends with cable fi ttings, to the
rudder servo arm. Use three M3 x 10 button head screws, three
M3 washers and three M3 lock nuts. Use a 2.5mm hex wrench and
5.5mm nut driver to tighten the hardware.
7. Thread the pushrod into the ball end on the servo arm. With the radio
system on, adjust the linkage so the rudder is centered when the
arm is on the servo. Do not install the servo arm screw at this time.
EN

TAIL WHEEL INSTALLATION

1. Use hobby scissors to trim the tail gear fairing.
 The installation of the tail gear fairing is optional.
2. Place medium grit sandpaper against the fuselage. Lightly sand the
tail gear fairing to match the shape of the fuselage.
3. Slide the latch toward the rear of the fuselage and remove the tail
gear cover. Set the cover aside.
4. Slide a sleeve on one end of the cable.
5. Pass the cable through the hole in the tail wheel arm. Pass the cable
back through the sleeve.
22