Horizon Hobby Hangar 9 Ki-43 Oscar 60cc Manuel D'utilisation page 10

5. Place tape around the slot in the aileron for the aileron control horn.
6. Remove the control horns from the control surfaces. Apply epoxy to
the slot in the aileron. Make sure the epoxy gets into the slot for a
good bond between the surfaces and control horn.
7. Apply epoxy to the area of the control horn that fi ts into the slot. Use
enough epoxy so the control horn will be fully bonded to the control
surfaces.
8. Before the epoxy fully cures, remove the tape from around the
control horn. This will allow the epoxy to fl ow around the control
horn, creating a small fi llet between the control horn and surface for
a fi nished look and secure bond. Allow the epoxy to fully cure before
proceeding.
9. Test fi t the remaining control horn. When gluing the control horn,
place the ball end between the horns and insert the M3 x 10 button
head screw through the control horns and rod ends. This will align
the horns correctly, making the linkage installation easier later.
EN
10. Once the epoxy has fully cured, pull on the control horn to make
sure it is glued securely in the aileron. If not, remove the control horn
and sand off any adhesives. Repeat this section to glue the control
horn in the aileron.
10