Pilot And Canopy Installation - Horizon Hobby Hangar 9 Ki-43 Oscar 60cc Manuel D'utilisation

15. Glue the tail wheel fairing to the tail wheel cover using contact
adhesive. Make sure not to glue the cover to the fuselage in case the
cover requires removal to access the tail gear.
EN

PILOT AND CANOPY INSTALLATION

1. When fi tting the pilot in the cockpit, the lower portion of the
instrument panel must be removed.
 Production models may not need the lower
portion of the instrument panel removed.
2. Carefully remove the lower instrument panel using a hobby knife
and #11 blade.
3. Use contact adhesive to glue the pilot in the cockpit. Allow the
adhesive to fully cure before proceeding.
4. Glue the head rest in position using medium CA or contact adhesive.
5. Glue the control stick in the cockpit using medium CA or 5-minute
epoxy. Position the control stick near the hands of the pilot when a
pilot has been installed.
24