Control Throws; Prefl Ight Checklist; Daily Flight Checks; Limited Warranty - Horizon Hobby Hangar 9 Ki-43 Oscar 60cc Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CONTROL THROWS

1.
Turn on the transmitter and receiver of your model. Check the movement of the rudder using the transmitter.
When the stick is moved to the right, the rudder should also move right. Reverse the direction of the servo at the
transmitter if necessary.
2.
Check the movement of the elevator with the radio system. Moving the elevator stick toward the bottom of the
transmitter will make the airplane elevator move up.
3.
Check the movement of the ailerons with the radio system. Moving the aileron stick to the right will make the
right aileron move up and the left aileron move down.
4.
Use a ruler to adjust the throw of the elevator, ailerons and rudder.
These are general guidelines for general sport and aerobatic fl ying from our own fl ight tests. You can experiment with
higher or lower rates to match your preferred style of fl ying.
Travel Adjust and Sub-Trims are not listed and should be adjusted according to each individual model and preference.
Always install the control horns 90 degrees to the servo center line. Use sub-trim as a last resort to center the servos.
Always re-bind the radio system once all the control throws are set to keep the servos from moving to their endpoints
until the transmitter and receiver connect.
Surface
Rate
High
Aileron
Low
High
Elevator
Low
High
Rudder
Low
Flaps
Ki-43 Oscar 60cc ARF
Direction
Throw
Up
25/32 inches (20mm)
Down
19/32 inches (15mm)
Up
19/32 inches (15mm)
Down
1/2 inches (13mm)
Up
1/2 inches (13mm)
Down
1/2 inches (13mm)
Up
13/32 inches (10mm)
Down
13/32 inches (10mm)
31
Left
1
/
inches (50mm)
32
Right
1
31
/
inches (50mm)
32
Left
1
3
/
inches (30mm)
16
3
Right
1
/
inches (30mm)
16
Take-Off
1–1
3
/
inches (25–30mm)
16
Landing
1
31
/
–2
3
/
inches (50–60mm)
32
8
PREFLIGHT CHECKLIST
• Charge the transmitter, receiver and motor batteries. Follow the instructions provided with the charger. Follow all
manufacturer's instructions for your electronic components.
• Check the radio installation and make sure all control surfaces (aileron, elevator, rudder, and fl aps) move correctly
(i.e., the correct direction and with the recommended throws).
• Check all the hardware (control horns, servo horns, and clevises) to make sure they are secure and in good condition.
• Prior to each fl ying session (and especially with a new model), perform a range check of your radio system. See your
radio manual for the recommended range and instructions for your particular radio system.

DAILY FLIGHT CHECKS

• Check the battery voltage of the transmitter battery. Do not fl y below the manufacturer's recommended voltage.
Doing so can cause your aircraft to crash.
• Check all hardware (linkages, screws, nuts, and bolts) prior to each day's fl ight. Ensure that binding does not occur
and that all parts are properly secured.
• Ensure all surfaces are moving in the proper manner.
• Perform a ground range check before each day's fl ying session.
• All servo leads and switch harness plugs should be secured in the receiver.

LIMITED WARRANTY

What this Warranty Covers
Horizon Hobby, LLC, (Horizon) warrants to the original purchaser that the product purchased (the "Product") will be free from
defects in materials and workmanship at the date of purchase.
What is Not Covered
This warranty is not transferable and does not cover (i) cosmetic damage, (ii) damage due to acts of God, accident, misuse,
abuse, negligence, commercial use, or due to improper use, installation, operation or maintenance, (iii) modifi cation of or to
any part of the Product, (iv) attempted service by anyone other than a Horizon Hobby authorized service center, (v) Product
not purchased from an authorized Horizon dealer, (vi) Product not compliant with applicable technical regulations, or (vii) use
that violates any applicable laws, rules, or regulations.
OTHER THAN THE EXPRESS WARRANTY ABOVE, HORIZON MAKES NO OTHER WARRANTY OR REPRESENTATION,
AND HEREBY DISCLAIMS ANY AND ALL IMPLIED WARRANTIES, INCLUDING, WITHOUT LIMITATION, THE IMPLIED
WARRANTIES OF NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. THE PURCHASER
ACKNOWLEDGES THAT THEY ALONE HAVE DETERMINED THAT THE PRODUCT WILL SUITABLY MEET THE REQUIREMENTS
OF THE PURCHASER'S INTENDED USE.
Purchaser's Remedy
Horizon's sole obligation and purchaser's sole and exclusive remedy shall be that Horizon will, at its option, either (i) service,
or (ii) replace, any Product determined by Horizon to be defective. Horizon reserves the right to inspect any and all Product(s)
involved in a warranty claim. Service or replacement decisions are at the sole discretion of Horizon. Proof of purchase is
required for all warranty claims. SERVICE OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE PURCHASER'S
SOLE AND EXCLUSIVE REMEDY.
35
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Han4720

Table des Matières