Aileron And Flap Servo Installation - Horizon Hobby HANGAR 9 Carbon Cub FX-3 Manuel D'utilisation

6. Apply epoxy to the unpainted area of the control horn. Make
sure to apply epoxy to the areas between the control horns.
7. Also apply epoxy to the remaining surfaces. A good bond
between the control horn and control surface is essential.
8. Place epoxy in the both slots in the control surface.
9. Insert the control horns in the control surface. Remove any
excess epoxy using a paper towel and isopropyl alcohol.
10. Before the epoxy cures, carefully remove the tape from the
control surface. Any uncured epoxy will create a fi llet between
the control horn and control surface.
 Install the control horns for the elevators,
flaps and ailerons at this time.
EN

AILERON AND FLAP SERVO INSTALLATION

11. Remove the tape and aileron servo cover from the wing.
Make sure to re-tape the string to the wing so it can be used
to pull the extensions through the wing later.
12. Check that the servo cover and mount are glued securely. If
not, use medium CA to glue the pieces together.
13. Clear any glue or debris from the holes in the servo mount
using a drill and 5/64-inch (2mm) drill bit.
14. Thread a servo mounting screw into each of the holes to cut
threads in the surrounding wood.
15. Remove the screws, then apply a few drops of thin CA in each
hole to harden the wood.
 Allow the CA to fully cure without using an accelerant.
The CA must be allowed to soak into the wood naturally.
6