Hinging The Elevators - Horizon Hobby HANGAR 9 Carbon Cub FX-3 Manuel D'utilisation

HINGING THE ELEVATORS

 Do not mix any epoxy until instructed to do so.
40. Separate the elevator and stabilizer. Remove the hinges.
41. Apply a small amount of oil to the fl ex point of the hinge to
prevent epoxy from entering the hinge.
42. Insert the hinge so the center of the hinge pin aligns with the
front edge of the bevel on the control surface. Check that the
hinge can move freely.
43. Position the hinge so it is perpendicular to the hinge line
when fully defl ected.
44. Mix 1/2 ounces (15mL) of 30-minute epoxy. Remove the
hinges, then use a toothpick to apply epoxy inside each of the
holes for the hinges.
EN
45. Apply epoxy to the outside of the hinge using a toothpick
46. Insert the hinges into the control surface. Verify the hinge
position is correct. Use a paper towel and isopropyl alcohol to
remove any excess epoxy.
47. Install all the hinges in the elevator. Allow the epoxy to fully
cure before proceeding.
 The hinges in the remaining elevator can be installed
while the first set of hinges and epoxy cures.
 Avoid holding the glued surfaces vertically as the epoxy may
run into the structure and settle on the inside surface of the
covering, which over time becomes visible from the outside.
48. Mix 1/2 ounces (15mL) of 30-minute epoxy. Use a toothpick
to apply epoxy inside each of the holes for the hinges.
49. Apply epoxy to the outside of the hinge using a toothpick
10