Interior Accessories - Horizon Hobby HANGAR 9 Carbon Cub FX-3 Manuel D'utilisation

INTERIOR ACCESSORIES

 The light control module is pre-programmed with multiple
flashing modes and sequences and is intended to be
set manually. It is relatively easy to make it operate
remotely using a servo to press the toggle button.
137. The lighting controller can be mounted inside the cockpit
using hook and loop tape. A servo can be used to press the
mode button on the controller. Make sure to set the amount
of throw on the servo so it does not damage the controller or
inside of the fuselage.
138. Thread the 1/4-20 x 7/8 inch nylon bolts into the nylon nuts
in the cockpit fl oor. Do not thread the nylon bolts against the
cockpit fl oor.
139. Slide the seat over the bolts. Adjust the height of the bolts
from the cockpit fl oor so the seat fi ts snugly when slide into
position.
 It may require adjustment of these screws and test fitting
the seat a number of times before the correct height
of the screw is set. When correctly adjusted, the seat
will fit securely, but still be removable when needed.
140. Repeat the previous steps to install the rear set in the
fuselage.
Carbon Cub FX-3
141. Secure the cockpit fl oor in the fuselage using the screws
removed earlier.
142. Mix 10g of 15-minute epoxy. Use epoxy to glue the
windshield supports into position.
 Use only enough epoxy to secure the supports in
position. Using too much epoxy will cause it to run
down the vertical surfaces inside the fuselage.
143. Thread the antenna into the blind nut inside the fuselage.
 Remove the antenna during transportation
and storage to avoid breakage.
144. Secure the instrument panel in the fuselage using three M3 x
10 button head cap screws. Use thread lock on the screws to
prevent them from vibrating loose.
23 EN