Elevator Servo Installation - Horizon Hobby HANGAR 9 Carbon Cub FX-3 Manuel D'utilisation

ELEVATOR SERVO INSTALLATION

34. Remove the tape, then radio cover, from the bottom of the
fuselage.
35. Remove the tape and elevator servo cover from the fuselage.
Make sure to re-tape the string to the fuselage so it can be
used to pull the extensions through the fuselage later.
36. Secure the elevator servo to the cover, Details are outlined
in the installation of the aileron servos. Secure a 36 inch
(915mm) extension to the servo lead. Install the servo arm
perpendicular to the servo center line.
37. Use the string in the fuselage to pull the elevator servo
extension through the fuselage.
 Use a helper to assist in guiding the extension
through the fuselage to avoid excessive pulling and
possibly separating the string and extension.
38. Secure the elevator servo cover to the fuselage using four M3
x 10 button head screws and four M3 washers. Make sure
to place a drop of canopy glue on each screw prior to their
installation.
Carbon Cub FX-3
39. Repeat the previous steps to install the remaining elevator
servo.
9 EN