Rudder Installation - Horizon Hobby HANGAR 9 Carbon Cub FX-3 Manuel D'utilisation

64. Mix 20g of 30-minute epoxy. Use an epoxy brush to apply
epoxy in the slot in the fuselage.
65. Use an epoxy brush to apply epoxy to the exposed wood on
the bottom of the fi n.
66. Fit the fi n back into position. Remove any excess epoxy using
a paper towel and isopropyl alcohol. Check that the fi n does
not move while the epoxy cures.
Carbon Cub FX-3

RUDDER INSTALLATION

67. Check the fi t of the rudder control horn in the slot in the
rudder.
68. View the rudder from the bottom. Make sure the control
horn is properly centered in the rudder. Check the fi t of both
control horns.
69. Remove the control horns and secure a ball end between the
control horns using an M3 x 15 socket head cap screw and
M3 lock nut. Leave the hardware slightly loose so the horns
can be manipulated during their installation.
70. Slide the control horns in the rudder. Apply epoxy to all the
points where the control horn will contact the wood of the
rudder. Slide the control horns into position and remove any
excess epoxy using a paper towel and isopropyl alcohol.
71. Install the hinges in the rudder following the steps outlined in
the elevator hinging section.
 There are two holes near the bottom of the rudder. The
lower hole is for the hinge, and one slightly above it is
for the position light lead. The string for the position light
lead will be in the correct location from the factory.
13
90˚
EN