Rudder Servo Installation - Horizon Hobby HANGAR 9 Tiger 30cc Manuel D'utilisation

RUDDER SERVO INSTALLATION

7
83. Thread an M3 nut on one end of a 41 / -inch (1064mm)
8
pushrod. Slide a retainer over the barrel of the clevises.
Thread the clevis on the pushrod until the end of the pushrod
is visible between the forks of the clevis. Insert the pushrod
into the pushrod tube at the rear of the fuselage. Attach the
clevis to the center hole of the control horn.
84. When attaching the ball end to the rudder servo horn, use the
hole that is 5/8 inch (16mm) from the center of the servo arm.
85. Attach the ball end to the servo arm using an M3 x 15 socket
head cap screw, two M3 washers and an M3 locknut. Thread
the ball end 10-turns on the pushrod.
86. Fit the rudder servo into the fuselage and attach the servo
arm. This will locate the correct position for the rudder servo.
Mount the servo in the fuselage
EN
87. Mix a small amount of 5-minute epoxy and use it to glue
the tail wheel steering tube in the rudder. Apply epoxy to the
bushing.
88. Apply epoxy in the slot on the bottom of the rudder.
89. Insert the steering tube into the slot. Remove any excess
epoxy using a paper towel and isopropyl alcohol. Allow the
epoxy to fully cure before proceeding.
5/8 inch
(16mm)
90. Loosen the wheel collar using a 1.5mm hex wrench and slide
it away from the mounting bracket.
91. Guide the tiller arm from the tail wheel assembly through the
steering tube. The bracket will rest fl at on the fuselage. If not,
carefully bend the tiller arm until the bracket rests fl at on the
fuselage.
14