Table des Matières
Publicité
rudder serVo and pull-pull cable installation • einbau Von höhenruderserVo und pull-pull-kabel • assemblage du câble « pull-pull » et du serVo
de la gouVerne de direction • installazione del serVo del timone e dei caVetti di comando
1
Prepare the servo by inserting the rubber grommets and brass eyelets
34
All manuals and user guides at all-guides.com
2
Install the ball link on the eye-bolt. Leave room for further adjustment.
3
Using a ¼-inch wrench and 3-32-inch ball driver, install the ball link on the
last straight hole on the servo arm.
Publicité
Table des Matières
