Control Surface Centering; Control Horn And Servo Arm Settings - Horizon Hobby E-Flite Pulse 15e Manuel D'utilisation

Control Surface Centering

After assembly and transmitter setup, confi rm that the control surfaces are
centered. If the control surfaces are not centered, mechanically center the
control surfaces by adjusting the linkages.
Change the length of the linkage at the servo arm. Loosen and tighten the set
screw on the servo arm using a 1.5mm hex wrench.
IMPORTANT: DO NOT use sub-trim and trim to center control surfaces. The
AS3X system requires sub-trim and trim set at 0.
After binding a transmitter to the aircraft receiver, set the trims and
sub-trims to 0, then adjust the linkages to center the control surfaces.

Control Horn and Servo Arm Settings

The table to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settings before making changes.
NOTICE: If control throws are changed from the factory settings, the AR636
gain values may need to be adjusted. Refer to the Spektrum AR636 manual for
adjustment of gain values.
After fl ying, you may choose to adjust the linkage positions for the desired
control response. See the table to the right.
Horns
Elevator
Ailerons
Rudder
Nose Gear
More control throw
EN
Arms
Less control throw
9