Horizon Hobby E-Flite Pulse 15e Manuel D'utilisation page 6

EN
Model Assembly Continued
Wing Assembly and Installation
Assembly
1. Slide both wing halves over the wing tube (A) until both wings meet
2. Ensure the aileron servo wires exit the wings through the hole where the
two wings meet (on the top side of the wing).
3. Connect the included Y-harness (B) to the aileron servo connectors (C).
IMPORTANT: The ailerons must be connected to the receiver's AILE (#2 chan-
nel) with a Y-harness (included) for the AS3X
Installation
4. Remove the battery hatch to gain access to the aircrafts receiver.
5. Insert the Y-harness connector in the fuselage hole and connect it to
receiver port number 2 (aileron).
Tip: If needed, use hemostats or pliers to pull the servo connectors into the
fuselage.
6. Install battery hatch.
7. Align the guide pins on the front of the wing in the fuselage plate holes and
secure the wing to the fuselage using 2 included screws (D).
CAUTION: DO NOT crush or otherwise damage the wiring when
attaching the wing to the fuselage.
Disassemble in reverse order.
6
@ system to function properly.
A
C
B
TOP of WING
D