Clevis Installation And Control Centering; Control Surface Centering; Control Horn And Servo Arm Settings - Horizon Hobby Force RC F-18 Blue Angel Manuel D'utilisation

EN

Clevis Installation and Control Centering

Clevis Installation
• Pull the tube from the clevis to the linkage.
• Carefully spread the clevis, then insert the clevis pin into the desired hole in the
control horn.
• Move the tube to hold the clevis on the control horn.

Control Surface Centering

After assembly and transmitter setup, confi rm that the control surfaces are
centered. If the control surfaces are not centered, mechanically center the control
surfaces by adjusting the linkages.
If adjustment is required, turn the clevis on the linkage to change the length of the
linkage between the servo arm and the control horn.
After binding a transmitter to the aircraft receiver, set the trims and
sub-trims to 0, then adjust the clevises to center the control surfaces.

Control Horn and Servo Arm Settings

The table to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settings before making changes.
NOTICE: If control throws are changed from the factory settings, the gain values may
need to be adjusted. Refer to your receiver manual for adjustment of gain values.
After fl ying, you may choose to adjust the linkage positions for the desired control
response. See the table to the right.
8
1
2
3
Horns
Elevator
Ailerons
More control throw
F-18 Blue Angel
4
5
6
Arms
Less control throw