Clevis Installation; Landing Gear Installation - Horizon Hobby Force RC F-18 Blue Angel Manuel D'utilisation

EN
Model Assembly
(Continued)
Vertical Stabilizer Installation
1. Apply CA to the base of the vertical stabilizer where it meets the fuselage.
2. Apply CA to the fuselage where the vertical stabilier fi ts.
3. Fit the vertical stabilizer in the slot.
Make sure the vertical stabilizer angles outward as shown. Also make sure
both vertical stabilizers are angled the same amount.

Clevis Installation

1. Attach the clevises to the control horns. Additional details are located on the
following pages.

Landing Gear Installation

1. Install (4) screws to attach the landing gear.
2mm X 8mm
5