Model Assembly Continued; Wing Installation; Control Surface Centering - Horizon Hobby E-FLITE P-47 Thunderbolt Manuel D'utilisation

EN

Model Assembly Continued

Wing Installation

1. Remove the canopy hatch.
2. Guide the Flaps, Retracts and Aileron servo connectors (A) through the hole
(B) located in the bottom of the fuselage as shown.
Tip: If needed, use hemostats or pliers to pull the servo connectors into the
fuselage.
3. Connect the Flaps, Retracts and Aileron connectors to respective Y-harness-
es connected to the receiver. The left and right servos can be connected to
either side of a Y-harness.
IMPORTANT: The ailerons must be connected to the receiver's AILE (#2 chan-
nel) with a Y-harness (included) for the AS3X
4. Mount the wing by aligning the wing's guide pins (C) with the fuselage's
bracket holes.
5. Secure the wing into position using the included three screws (D).
CAUTION: DO NOT crush or otherwise damage the wiring when
attaching the wing to the fuselage.
6. Reinstall the canopy hatch on the fuselage.
Disassemble in reverse order.
Clevis Installation
• Pull the tube from the clevis to the linkage.
• Carefully spread the clevis, then insert the clevis pin into the desired hole in
the control horn.
• Move the tube to hold the clevis on the control horn.

Control Surface Centering

After assembly and transmitter setup, confi rm that the control surfaces are
centered. If the control surfaces are not centered, mechanically center the
control surfaces by adjusting the linkages.
If adjustment is required, turn the clevis on the linkage to change the length of
the linkage between the servo arm and the control horn.
After binding a transmitter to the aircraft receiver, set the trims and
sub-trims to 0, then adjust the clevises to center the control surfaces.
6
@
system to function properly.
C
B B B
1.
2.
3.
A
Flaps
Gear
Ailerons
D
4.
5.
6.