Transmitter Setup (Bnf); Dual Rates; Model Assembly - Horizon Hobby E-flite A-10 Thunderbolt II 64mm Twin EDF Manuel D'utilisation

EN

Transmitter Setup (BNF)

IMPORTANT: After you set up your model, always rebind the transmitter and
receiver to set the desired failsafe positions.
If your transmitter allows it, enable the throttle cut feature. Always engage
throttle cut before approaching the aircraft.

Dual Rates

Low rate is recommended for the initial fl ights.
NOTICE: To ensure AS3X ® technology functions properly, do not lower rate
values below 50%. If lower rates are desired, manually adjust the position of
the pushrods on the servo arm.
NOTICE: If oscillation occurs at high speed, refer to the Troubleshooting
Guide for more information.
Expo
After fi rst fl ights, you may adjust expo in your transmitter.
† Some of the terminology and function locations used in the iX12
programming may be slightly different than other Spektrum AirWare™
radios. The names given in parenthesis correspond to the iX12 programming
terminology. Consult your transmitter manual for specifi c information about
programming your transmitter.
* Flap programming values may vary slightly. For your initial fl ights use the
recommended fl ap travel settings provided in the Flaps section and adjust the
fl ap travel to your preference on subsequent fl ights.
‡ The settings provided are for the DX6 and DX6e and do not allow for the use of a
SAFE Select switch. To use a SAFE Select switch on these systems see the section
for transmitter setup and operation information.

Model Assembly

Horizontal Tail Installation
1. With the bottom of the fuselage facing up, connect the rudder and elevator
servo connectors and push the excess servo wire into the pocket.
2. Apply medium CA to all joining surfaces of the horizontal stabilizer, press
the horizontal stabilizer into place and allow to cure. Ensure the stabilizer is
perpendicular to the centerline of the fuselage.
4
Computerized Transmitter Setup
‡ ‡
(DX6e , DX6 , DX7, DX7S, DX8, DX8e, DX9, DX10t, DX18, DX20 and iX12)
Start all transmitter programming with a blank ACRO model (do a model
reset), then name the model.
HIGH 100%
Set Dual Rates to:
LOW 70%
Set Servo Travel to: 100%
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Set WING TYPE: 1 AIL 1 FLAP
4. Go to the FUNCTION LIST
DX7S
5. Set SERVO SETUP: Reverse Gear
DX8
6. Set FLAP SYSTEM: Choose Flap
NORM: -100% FLAP*
Take-off: -10% FLAP*
LAND: 70% FLAP*
DX6e ‡
1. Go to the SYSTEM SETUP (Model Utilities)
DX6
2. Set MODEL TYPE: AIRPLANE
(Gen2) ‡
3. Set AIRCRAFT TYPE (Model Setup, Aircraft Type)
DX7
WING: 1 AIL 1 FLAP
(Gen2)
4. Go to the FUNCTION LIST (Model Adjust)
DX8
5. Set SERVO SETUP: Reverse Gear
(Gen2)
6. Set FLAP SYSTEM:
DX8e
SELECT SWITCH D:
DX9
POS 0: -100% FLAP*
DX10t
POS 1: -10% FLAP*
DX18
POS 2: 70% FLAP*
DX20
iX12 † SPEED 2.0
A-10 64mm Twin EDF
0% ELEV
10% ELEV
12% ELEV
†
† :
†
0% ELEV
10% ELEV
12% ELEV