Horizon Hobby E-flite A-10 Thunderbolt II 64mm Twin EDF Manuel D'utilisation page 5

Model Assembly (Continued)
Vertical Fin Installation
1. Connect the rudder servo connector to the extension in the horizontal
stabilizer. Secure the connection with tape.
2. Apply the decal over the servo and servo wire as shown. Feed the excess servo
wire into the pocket at the end of the horizontal stabilizer.
3. Apply medium CA to all joining surfaces of the left vertical fi n, press into
place and allow to cure. Ensure that the vertical fi n is perpendicular to the
horizontal stabilizer.
4. Install the right vertical fi n onto the opposite side of the horizontal tail
following the previous steps.
EN
5