Safe ® Select Switch Designation; Select With The Dx6 And Dx6E Transmitters; With A 6 Channel Aircraft - Horizon Hobby E-flite A-10 Thunderbolt II 64mm Twin EDF Manuel D'utilisation

EN
®
SAFE Select Switch Designation
SAFE ® Select technology can be easily assigned to any open switch (2 or 3
position) on your transmitter. With this feature, you have the fl exibility to enable
or disable the technology while in fl ight.
IMPORTANT: Before assigning your desired switch, ensure that the travel for
that channel is set at 100% in both directions and the aileron, elevator, rudder
and throttle are all on high rate with the travel at 100%. Turn throttle hold OFF
if it is programmed in the transmitter.
CAUTION: Keep all body parts well clear of the rotor, intakes and
exhaust tube and keep the aircraft securely restrained in case of
accidental throttle activation.
Assigning a switch
1. Bind the aircraft correctly to activate SAFE Select. This will allow the
system to be assigned to a switch.
2. Hold both transmitter sticks to the inside bottom corners and toggle the
desired switch 5 times (1 toggle = full up and down) to assign that switch.
The control surfaces of the aircraft will move, indicating the switch has
been selected.
Repeat the process to assign a different switch or to deactivate the current
switch if desired.
TIP: SAFE Select is assignable on any unused Channels 5–9.
®
Using SAFE Select With the DX6 and DX6e Transmitters With a 6 Channel Aircraft
The SAFE Select switch must be assigned to the Flap switch (switch D)
BEFORE proceeding to the Transmitter Setup and should start from a blank
(reset) model. Failure to assign the SAFE switch prior to programming the other
model functions may prevent the SAFE switch from assigning correctly. Users
of the DX6 and DX6e will have the SAFE Select functionality linked to the fl aps.
The values given in the Transmitter Setup table turn SAFE ON when the fl aps
are fully deployed. SAFE is OFF when the fl aps are not fully deployed.
IMPORTANT: When programming the Flap System function in the transmitter
setup of the DX6 and DX6e, set the Speed value to Norm. Adding any delay to
the deployment of the fl aps will also delay the activation of SAFE.
10
Mode 1 and 2 transmitters
DX6 and DX6e Transmitter Setup for SAFE
Start all transmitter programming with a blank ACRO model (do a model
reset), then name the model.
HIGH 100%
Set Dual Rates to:
LOW 70%
Set Servo Travel to: 100%
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Set AIRCRAFT TYPE:
WING: 1 AIL 1 FLAP
4. Go to the FUNCTION LIST
DX6e
5. Set SERVO SETUP: Reverse Gear
DX6
®
See the SAFE Select Switch Designation section BEFORE setting
(Gen2)
the fl ap values.
6. Set FLAP SYSTEM:
SELECT SWITCH D:
POS 0: -100% FLAP
POS 1: -10% FLAP
POS 2: 70% FLAP
A-10 64mm Twin EDF
100%
X 5
100%
®
Select Operation
0% ELEV
10% ELEV
12% ELEV