As3X Control Direction Test; In Flight Trimming - Horizon Hobby E-flite A-10 Thunderbolt II 64mm Twin EDF Manuel D'utilisation

AS3X Control Direction Test

®
This test ensures that the AS3X control system is functioning properly.
Assemble the aircraft and bind your transmitter to the receiver before
performing this test.
1. Raise the throttle to any setting above 25%, then lower the throttle to
activate AS3X technology.
CAUTION: Keep all body parts, hair and loose clothing away from the
fan intake, as these items could become entangled.
2. Move the entire aircraft as shown and ensure the control surfaces move in
the direction indicated in the graphic. If the control surfaces do not respond
as shown, do not fl y the aircraft. Refer to the receiver manual for more
information.
Once the AS3X system is active, control surfaces may move rapidly. This is
normal. AS3X remains active until the battery is disconnected.

In Flight Trimming

During your fi rst fl ight, trim the aircraft for level fl ight at 3/4 throttle with the
gear up. Make small trim adjustments with your transmitter's trim switches to
straighten the aircraft's fl ight path.
After adjusting trim do not touch the control sticks for 3 seconds. This allows the
receiver to learn the correct settings to optimize AS3X performance.
Failure to do so could affect fl ight performance.
After landing, adjust the linkages mechanically to account for trim changes and
then reset the trims to neutral. Ensure the aircraft will fl y straight and level with
no trim or sub-trim.
Aircraft
Movement
AS3X Reaction
3 Seconds
EN
13